How to woven ribbon belt

How to woven ribbon belt

One tape can make the product a new shade, and several intertwined ribbons to completely change its look.

These tapes can be used as a belt. Its width depends on the width of the tape. Of the 1.5 cm wide tape obtained belt width 3.8 cm.

To make a belt of woven tapes, measure out

Delije at the waist line and add 3.8 cm for the finishing end. Cut four lengths of double-sided tape. Each segment is a third longer than the length of the finished belt. For example, if the belt should be 68.5 cm, each piece of tape – 91.5 cm.

To handle all belts used strong tape Gros Gros. Its length should be ten times larger than the width of the double-sided tape.

How to make a belt of woven ribbons 1) Connect the two tapes. Let them: Tape 1, Tape 2, the tape 3 and 4 tape. 2) Cleave the tape at a right angle, as shown in the photo. Woven tape 2 tape 3 under the top of the belt 4; tape 3 over the tape 2 for the tape 1; 4 tape under the belt 2 on top of the tape 1. 3) Remove the tape 3 and 4 in the direction of tape strips 1 and 2. 4) Remove the tape 2 back, get it under the tape 1, on top of the tape and a tape 3 4. 5) Remove the tape 1 back, get it under the tape 3 and 4 on top of the tape. 6) Remove the tape 1 and 2 to the direction of tape 3 and 4. 7) Remove the tape 3 back, get it under the belt 4, on top of the tape and a tape 2 1. 8) Remove the tape 4 back, get it under the belt 2 and the top of the belt 1. Repeat steps 3 through 8 until weave belt of the desired length. 9) Sew the ends of the lateral line. Cut two strips of tape Gros Gros width of 1.5 cm and a length of 1.3 cm more than the width of woven ribbons. 10) Tuck the ends of the ribbon Gros Gros is 6 mm. Attach one long edge of the strip to the line of stitches on the front and reverse side. Stitch along the edge of the tape. 11) Cut the sharp ends of the belt, leaving 6 mm. Remove the strip back so as to close the ends of the belt. Secure in her arms. Sew hooks and loops.

Leave a Reply

Your email address will not be published. Required fields are marked *

Close